EC Fluoro-Guard Protector

For carpets and fabrics:

Use the product as it is, without diluting it.

Hold the spray bottle 6-12 inches away from the fabric.

Spray a light mist evenly over the entire area, ensuring the surface is wetted.

The fabric will dry within 30 minutes to 2 hours.

It takes 24 hours for the product to reach full repellency on the fabric.

For application to tile, grout, and stone surfaces:

Use a pump-up applicator to apply "Extremely Clean Fluoro-Guard" on the tile and grout surface.

Use a flat (microfiber) mop to spread the product evenly over the entire surface.

Pay special attention to filling in the grout lines while applying and move around the sealer.

Start applying the product in a far corner and work your way out.

Additional recommendations:

It is suggested to speed up the drying process by using air movers to make the surface available for quick use.

There is no need to buff off the product. It will dry and flash off the tile surface without leaving any haze or residue.

If by any chance there is a haze or residue, you can reactivate that area with the Fluoro-Guard and wipe it, allowing it to dry again.

To prevent haze or residue, avoid walking on the treated area before it is completely dry.

Allow the product to dry without any foot traffic for a couple of hours.

The coverage on carpets and fabrics is approximately 800-1100 square feet per gallon. The coverage on tile and grout surfaces is even better.

Important precautions:

Avoid inhaling the vapors of the product.

Use the product outdoors or in a very well-ventilated area.

Please note that these instructions are specific to the product "Fluoro-Guard" and should be followed accordingly.